Hardtail Sections



Rubber Mount Sportster Weld-on Tail Sections 2004-UP

  • Made of 1.25" .120 wall ERW tubing
  • Has 4" of stretch
  • Sits the frame Aprox 5-5.5" off the ground, sits level with hugger fork tubes
  • Rear axle plates can be either 3/4" or 1"
  • Allows you to run a stock rear tire up to a 180mm (running a 180mm requires a 1/8" offset to the left)
  • Installation instructions are provide upon purchase
  • Kit includes two isolator dampners and a chain tensioner
  • Rear Gas tank mount will have to be fabricated with the new tail section
  • The factory exhaust bracket will NOT work with the tail section
  • All of your stock rear master cylinder parts will bolt right up after the tail section installed and mid or forward linkage will not require modification
  • No wiring modifications are required when using our battery box and electrical panel except for the tail/brake light on Carbureted models
  • Chain conversion required

Photos

Base Price:
$500 - includes the chain tensioner and dampners
Installation of the tail section: $175 plus return shipping
Rear axles: 3/4" with castle nuts and cross drilled for pins $45 or 1" with castle nuts and cross drilled for pins $55
Rear axle adjusters blocks with bolts and jam nuts: $40
We do offer a complete build service if you wish to just drop off your stock bike and pick it up after we chop/bob it: $$ depends on customers needs
© 2005-2010 kansaskustom.com